Table of Contents
Advertisement
NOTE: This screen corresponds to the choice "non-active quantities broken down" in the VAR tab of the Calculation
Methods menu of the Configuration mode. If "non-active quantities not broken down" is selected, D (distortion power) does
not appear and Q
Filters L2 and L3 display the same information for phases 2 and 3.
Φ
is displayed for the 2-wire two-phase set-up.
UA
10.2.2.
ENERGY METERS DISPLAY SCREEN
The Wh... sub-menu displays the energy meters.
Meters of energy consumed by
Active energy.
DC energy (only if a DC current
sensor is connected).
Reactive energy.
Distortion energy.
Apparent energy.
NOTE: This screen corresponds to the choice "non-active quantities broken down" in the VAR tab of the Calculation
Methods menu of the Configuration mode. If "non-active quantities not broken down" is selected, Dh (distortion energy) does
not appear and Q
Filters L2 and L3 display the same information for phases 2 and 3.
10.3. FILTER Σ
10.3.1.
TOTAL POWERS AND ASSOCIATED QUANTITIES DISPLAY SCREEN
The W... sub-menu displays the powers and associated quantities.
Total active power.
Total DC power.
Total reactive power.
Total distortion power.
Total apparent power.
NOTE: This screen corresponds to the choice "non-active quantities broken down" in the VAR tab of the Calculation Methods
menu of the Configuration mode. If "non-active quantities not broken down" is selected, D (distortion power) does not
appear and Q
is replaced by N. This non-active power has no inductive or capacitive effect.
1
is replaced by N. This non-active power has no inductive or capacitive effect.
1
the load.
h is replaced by Nh. This non-active energy has no inductive or capacitive effect.
1
Figure 10-6
Figure 10-7
76
Meters of the energy generated by
the load
Inductive reactive effect
.
Capacitive reactive effect
Total power factor (PF).
Total fundamental power factor (also
called displacement factor - DPF).
Total tangent of the phase shift.
.
Advertisement
Table of Contents
