Table of Contents
Advertisement
The
button displays power- and energy-related measurements.
The available sub-menus depend on the filter.
■
For 2- and 3-wire single-phase connections and for the 2-wire two-phase connection, only L1 is available. The filter
therefore not displayed, but the display is the same as for L1.
■
For the 3-wire three-phase connection, only Σ is available. The filter is therefore not displayed, but the display is
for Σ.
10.1. 3L FILTER
10.1.1. POWERS DISPLAY SCREEN
The W... sub-menu is used to display the powers.
Active power.
DC power (only if a DC current
sensor is connected).
Reactive power.
Distortion power.
Apparent power.
NOTE: This screen corresponds to the choice "non-active quantities broken down" in the AR tab of the Calculation
Methods menu in Configuration mode. If "non-active quantities not broken down" is selected, D (distortion power) is not
displayed and Q1 appears in place of N. This non-active power is unsigned and has no inductive or capacitive effect.
10.1.2. QUANTITIES ASSOCIATED WITH THE POWERS DISPLAY SCREEN
The PF sub-menu... displays the quantities associated with the powers.
Power factor.
Fundamental power factor (also
called displacement factor -
Tangent of the phase shift.
Phase shift of the voltage
with respect to the current.
10.
POWER AND ENERGY MODE
DPF).
Figure 10-1
Figure 10-2
74
is
the same as
Advertisement
Table of Contents
