Table of Contents
Advertisement
1.5. BATTERY CHARGING
Before first use, fully charge the battery.
120 V ± 10 %, 60 Hz
230 V ± 10 %, 50 Hz
It is also possible to charge the battery using the voltage on the voltage measurement terminals. To do this: with the connector cover
removed, connect the power supply cord to the battery charging connector and the two safety-series banana plugs with rear-mounted
sockets to any two of the phases (L1, L2, L3).
To make measurements while charging the battery, connect the measurement leads to the terminals and to the safety- series banana
plugs with rear-mounted sockets.
The
When the battery is fully discharged, charging takes approximately 5
hours.
Figure 1-1
Figure 1-2
Figure 1-3
1.
Remove the connector cover on the instrument (see Figure 1-1).
2.
Connect the AC power cord and screw it in place.
3.
Plug the power cord into a power outlet.
button lights; it will go out only when the plug is disconnected.
8
Advertisement
Table of Contents
