Table of Contents
Advertisement
Instructions for use
4.1.2 Preparations before filling
Numbers in brackets refer to the diagram in the chapter "The machine's design".
Check:
•
•
•
•
Fit:
•
•
•
Detergent and drying agent
•
•
4.1.3 Filling the machine
Numbers in brackets refer to the diagram in the chapter "The machine's design".
•
•
•
•
NOTE: It is not possible to close the doors if the locking arms are not locked.
NOTE: The time needed to heat the water to the right wash temperature depends
on the temperature of the incoming water.
WD-18CW
that the machine has been cleaned and that the stopcocks on the water
supply are open.
that the mains switch and the circuit breakers are in position 1.
that the rubber seal (19) is undamaged.
the amount of detergent and drying agent.
the level pipe (22) and the filter (18). The rubber seal of the level pipe (19)
must be sealed against the bottom plate.
the filter (18)
the drain tap (20) must be closed.
When use liquid detergent and drying agents should the same make and
type uses.
Washing-up liquid must not be used in the machine or for pre-treating items
(soaking, pre-washing, etc.). Washing-up liquid causes a build-up of foam,
produces poor wash results and can damage the machine.
Press button (6) to switch on the power supply.
Press one of the programme buttons P1, P2 or P3 (10).
The machine will start to fill with water.
Messages indicating the sequence of events appear on the display (1).
26
Rev. 3,0 (201802)
Advertisement
Table of Contents
