Starting The Wash Programme; Guaranteed Final Rinse - Wexiodisk WD-18CW Installation And User Manual

Trolley dishwasher
Hide thumbs Also See for WD-18CW:
Table of Contents

Advertisement

Instructions for use

4.2.2 Starting the wash programme

Machine with a single door
Machine with double doors
Machine with a clean and dirty side

4.2.3 Guaranteed final rinse

The right amount of rinse water is always used for the final rinse and there is also
the option of ensuring that the temperature of the final rinse water is always cor-
rect.
If the flow during the final rinse is too low, an alarm is displayed on the control pan-
el. The alarm can also be set up to stop the machine. The factory setting is for an
alarm only. If you need an alarm which stops the machine, the setting must be
changed by a service engineer in the machine's software.
Optional: If the rinse temperature is too low, an alarm is triggered on the control
panel. The machine continues washing until the right temperature is reached.
However, the alarm can be reset in the meantime by pressing button (7) on the
panel. The wash programme continues, but the machine will then rinse at a lower
temperature. However, an alarm is displayed.
WD-18CW
Push in the carts and close the gates (17). Lower the locking arms by
pressing control button (12). Close the door by pressing control button (13).
The wash programme starts when the door is closed. The door opens au-
tomatically around 10 seconds after the wash programme has finished.
Lower the rear locking arm by pressing control button (11). Push in the
carts and close the gates (17). Lower the front locking arm by pressing con-
trol button (12). Close the doors by pressing control button (13).
The wash programme starts when the doors are closed. The doors open
automatically around 10 seconds after the wash programme has finished.
When the carts are pushed in, the rear door must always be closed. Oth-
erwise the procedure for loading and starting the machine is the same as
for a machine with double doors.
After the wash programme has finished, only the rear door opens. The
carts are pulled out and the door is closed by pressing the control button
on the rear of the machine next to the door. When the rear door is closed,
the front door opens automatically and new carts can be loaded into the
machine.
32
Rev. 3,0 (201802)

Advertisement

Table of Contents
loading

Table of Contents