Table of Contents
Advertisement
Installation
3.6 Adjusting the rotation table
2
2
1
D335_1
Floor of the machine showing rotation table and floor plates
1.
Rotation table
2.
Support rollers
3.
Sill plate
4.
Location of support legs
5.
Rotation table start position markers
•
After installing the machine, the rotation table (1) needs to be adjusted to
the correct level. This is done using the two support legs located under the
machine at (4).
•
If the machine is mounted on a stand, check that the stand is adjusted to
the correct height and that the machine is horizontal.
•
Check that both sill plates (3) are in place.
•
The rotation table (1) must be in its start position. The markers (5) on the
rotation table and sill plate must be exactly aligned.
•
Adjust the support legs though both holes at (4). There is a nut welded to
the top of each leg. Use a ratchet spanner to adjust the legs to the correct
position. Turn to the right to screw the legs downwards and to the left to
screw them upwards. Screwing the legs to the right or left raises or lowers
the rotation table.
•
Check under the machine to ensure that the legs are touching the floor. If
the machine is recessed into the floor, remove the cover plates around the
machine to check the legs.
•
If the rotation table (1) is adjusted to the correct position, the top of the ro-
tation table should be at the same level as the top of both the sill plates (3).
In this position, the rotation table should not be resting on the four support
rollers (2).
WD-18CW
17
Rev. 3,0 (201802)
3
2
4
2
3
5
Advertisement
Table of Contents
