Table of Contents
Advertisement
Installation
3.7 Adjusting the locking arms
The control button (6) must be switched on in exactly the right position.
1.
2.
3.
4.
5.
6.
7.
It is important to adjust the locking arms (1) to avoid the machine from being start-
ed without the gates having been locked.
•
•
•
•
•
WD-18CW
Locking arm
Upper gate bar
Circular rod, Ø 6 mm
Sensor plate
Screw
Locking arm control button
Inductive sensor
Power to the controls needs to be on to make adjustments.
Close the gates.
Pull the locking arm (1) down. When the upper edge of the circular rod (3)
is level with the underside of the upper gate bar (2), switch on the locking
arm control button (6) on the panel. If the control button does not switch on
in this position, the sensor plate (4) needs to be adjusted.
Undo the screw (5) and move the sensor plate (4) up or down. Continually
check whether the control button (6) switches on in exactly the right posi-
tion by pulling the locking arms down.
If the machine has doors on both sides, adjust both locking arms.
18
1
2
3
3
7
4
1
5
Rev. 3,0 (201802)
1
2
D336_3
6
D336_4
18CW_336_r1
Advertisement
Table of Contents
