Configuring Te/Ip - Intermec 6400 User Manual

SECTION 2

Configuring TE/IP

" NOTE:
For 3270, 5250, or VT/ANSI terminal emulation (TE) over
TCP/IP, the host is usually specified by an IP address
(unless you are using a domain name server). However,
often the 6400 TCP/IP client needs to know the port on
which the host application is residing. The default port
number (23) is automatically assumed in TE/IP.
If the application is residing on the default port (23), you
need to enter only the host IP address for the terminal
emulation program's host name" parameter. If the
application resides on a port other than 23, specify the IP
address and other port as follows.
If you are using DHCP, you do not need to specify a host IP address
and a port number for the host name parameter.
1. Configure the 6400 TCP/IP client with an IP address,
subnet mask and, if necessary, a router address. If
your network uses a domain name server, configure an
IP address for it. For more information about setting
IP addresses, see pages 2 6 through 2 7.
2. Open the 6400 TCP/IP client's PCTCP.INI file. In the
[pctcp general] section, enter the following:
host–table = c:\<pathname>\<host table filename>
For example:
host–table=c:\hosts
6400 Computer TCP/IP Client User's Guide
6400 TCP/IP Client
2-13