Disabling The Dos Snmp Agent; Snmp Command Summary - Intermec 6400 User Manual

SECTION 2
SEE ALSO:

Disabling the DOS SNMP Agent

To unload the DOS SNMP agent, you must unload the TSR
kernel and remove the snmpd program from memory. To
unload the SNMP agent, do one of the following:
If you enabled the SNMP agent through the DOS
"
configuration menus, disable it through the DOS
configuration menus and then reboot your 6400
computer. For more information, see page 2 9.
If you manually started the SNMP agent at the DOS
"
prompt, disable the agent by rebooting your 6400
computer.

SNMP Command Summary

snmpd
snmpd [? | -version]
The snmpd command lets other hosts using SNMP
examine your 6400 computer's statistics and configuration
information. Snmpd starts an SNMP agent.
-? Displays and explains the command's usage
line.
-version Displays the version and patch level of this
command. Refer to this information if you call
Technical Support.
Inet (page 2-27), Ethdrv (page 2-31), and these RFCs:
RFC 1065, Structure and Identification of Management Information
for TCP/IP–Based Internets
RFC 1067, A Simple Network Management Protocol
6400 Computer TCP/IP Client User's Guide
6400 TCP/IP Client
2-63