Intermec 6400 User Manual page 119

APPENDIX A
" NOTE:
6. Type the following command at your 6400 computer's
DOS prompt:
D:\>124.bat
This command boots your 6400 computer from the
RAM (D) drive and then resets it. When your 6400
computer resets, it begins the Flash update process.
You are not prompted further unless an error occurs or
a file is missing.
If your 6400 computer does not reset, you may need to do a
4-key reset. For instructions, see "Resetting Your 6400
Computer" on page A-8.
After reflashing, your 6400 computer resets and
reboots to C drive.
7. To confirm the Flash version, observe the screen while
your 6400 computer is booting from C drive.
Or, you can display the version by typing the correct
command at the prompt. For the 2.4 GHz OpenAir
radio, type:
C:\>64ippr10.nam
For the 802.11 DS radio, type:
C:\>64iplu10.nam
8. When the update is complete, COMMAND.COM,
RB.BAT, and RESET.EXE are present on the RAM (D)
drive. If you want, you can delete these files and the
RAM (D) drive.
9. Note that AUTOEXEC.BAT has been renamed to
AUTOEXEC.BAK, and CONFIG.SYS has been
renamed to CONFIG.BAK.
INTERSVR/INTERLNK Connection
6400 Computer TCP/IP Client User's Guide A-7