Installing The 6400 Tcp/Ip Client - Intermec 6400 User Manual

APPENDIX A
" NOTE:
5. Your personal computer must be running INTERLNK,
which is part of MS DOS. Load INTERLNK as a
device driver by entering the file's pathname in your
personal computer's CONFIG.SYS file. For example,
the following statement assumes MS DOS is located
in the C:\DOS directory on the personal computer:
DEVICE=C:\DOS\INTERLNK.EXE /DRIVES:3
The /DRIVES:3" parameter allows the mapping of
three drives from your 6400 computer.
6. Insert the pathname at the end of CONFIG.SYS, after
any other statement that creates a drive letter.
7. Connect your 6400 computer to your personal
computer. See Connecting the Computers" on page
A 1.

Installing the 6400 TCP/IP Client

1. Begin the installation with your 6400 computer at the
C:\ prompt.
You may need to reboot your 6400 computer to get to the C:\
prompt. For instructions, see "Rebooting Your 6400
Computer" on page A-8.
2. Type the following command at the prompt:
C:\>6400.bat
6400.BAT creates a 960 KB RAM (D) drive, adds D
drive to the path, and makes your 6400 computer's A,
C, and D drives available to INTERLNK.
INTERSVR/INTERLNK Connection
6400 Computer TCP/IP Client User's Guide A-5