Enabling Or Disabling The Dhcp Client; Enabling Or Disabling The Snmp Agent - Intermec 6400 User Manual

6400 TCP/IP Client
" NOTE:
" NOTE:
2-16 6400 Computer TCP/IP Client User's Guide
Enabling or Disabling the DHCP
Client
To execute a DHCP request, type the following at the DOS
prompt:
C:\>dhcp
You can automatically execute a DHCP request when you start your
6400 computer by entering the dhcp command in AUTOEXEC.BAT.
The dhcp command must be located after ETHDRV.EXE.
To disable DHCP, reboot your 6400 computer or type the
following command at the DOS prompt:
C:\>dhcp –u
For more information about the DHCP client, see page
2 8.
Enabling or Disabling the SNMP
Agent
To enable the SNMP agent, type the following at the DOS
prompt:
C:\>snmpd
You can automatically enable the SNMP agent when you start your
6400 computer by entering the snmpd command in
AUTOEXEC.BAT. The snmpd command must be located after
ETHDRV.EXE.
To disable the SNMP agent, reboot your 6400 computer.
For more information about the SNMP agent, see page
2 9.
SECTION 2