Setting The Security Id; Setting The Network Name; Setting The Sleep Timeout - Intermec 6400 User Manual

SECTION 2
" NOTE:
" NOTE:

Setting the Security ID

Security ID applies only to the 2.4 GHz OpenAir radio.
1. Type the following at the DOS prompt:
C:\>proxstat –s<security_id>
where <security_id> is the set of characters to be used
as the security ID. If you do not specify a setting for
the -s switch, the security ID is set to " (deleted).
2. Reboot your 6400 computer for the change to take
effect.
For more information about the security ID, see page 2 10.

Setting the Network Name

Network name applies only to the 802.11 DS radio..
1. Use a text editor to open NET.CFG.
2. Modify the setting for WaveLAN_Network_Name
(default: INTERMEC"). Note that the network name
is in quotes.
For more information about the name, see page 2 11.

Setting the Sleep Timeout

1. Use a text editor to open AUTOEXEC.BAT.
2. Modify the /D switch for ELANCFG. Following is a
sample command line:
elancfg /V1 /T2 /D24 /L1 /H1
The range is 0, or 4 to 1024 in increments of 4
seconds. A value of 0 disables autosuspend.
3. Reboot your 6400 computer for the change to take
effect.
For more information about sleep timeout, see page 2 12.
6400 Computer TCP/IP Client User's Guide
6400 TCP/IP Client
2-17