Trap Receiver Commands - Eaton Network Card-MS User Manual

Table 15. Network Commands (Continued)
setSNMP
Syntax
Options
Example
Comments

Trap Receiver Commands

Use trap receiver commands to configure the stations receiving traps (see Table 16). The maximum number of
trap receivers is three.
Table 16. Trap Receiver Commands
getTrap
Syntax
Options for N = 0 | 1| 2
Example
setTrap
Syntax
Options for N = 0 | 1| 2
Example
Comment
getSNMP [option1] [option2] . . .
snmpVersion = Disabled | V1 | V3 | V1V3
ReadCommunityName = "xx..xx"(See Note 1)
WriteCommunitySecurityLevel = 0 | 2(0=No, 2=Yes)
WriteCommunityName = "xx..xx"(See Notes 1, 2)
User = "xx..xx"(See Note 1)
UserSecurityLevel = 1 | 2 | 3(1=No Auth, 2=Auth NoPriv, 3=Auth Priv)(See Note 1)
UserPassword = "xx..xx"(See Notes 1, 3, 5, 6)
Admin = "xx..xx"(See Note 1)
AdminSecurityLevel = 1 | 2 | 3(1=No Auth, 2=Auth NoPriv, 3=Auth Priv)(See Note 1)
AdminPassword = "xx..xx"(See Notes 1, 4, 5, 6)
NotificationUserName = "xx..xx"
FirmwareUpgrade = 0 | 1(0=No, 1=Yes)
#> setSNMP User = "readuser"
Note 1: Setting is write-enabled depending on "snmpVersion" status.
Note 2: Setting is write-enabled depending on "WriteCommunitySecurityLevel" status.
Note 3: Setting is write-enabled depending on "UserSecurityLevel" status.
Note 4: Setting is write-enabled depending on "AdminSecurityLevel" status.
Note 5: Remember to set echo off.
Note 6: Minimum length is 8 characters.
getTrap N [option1] [option2] . . .
HostName | Name | TrapCommunity | TrapSnmpVersion | TrapSelectedMibs
#> getTrap 1 HostName Name
setTrap N [option1] [option2] . . .
HostName = "xx..xx"
Name = "xx..xx"
TrapCommunity = "xx..xx"
TrapSnmpVersion = Disabled | V1 | V3 | V1V3
TrapSelectedMibs = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7(See Note 1)
#> setTrap 0 Name="My application"
Note 1:bit0 = 1: MIB Pulsar enabled
bit1 = 1: Power MIB enabled
bit2 = 1: MIB IETF enabled
Eaton Network Card-MS User's Guide P-164000100—Rev 1 www.eaton.com/powerquality
Using the Telnet/SSH/CLI Interface
Modify an SNMP setting.
57