Testing The Configuration - Eaton Network Card-MS User Manual

2. Follow the instructions and enter the static IP parameters.
Wait until Done displays, indicating that the IP parameters have been saved.
3. To exit, type 0 and press Enter.
4. Type 1 and press Enter, and then type 2 and press Enter to restart.
The card restarts with the new IP settings in approximately one minute.
NOTE

Testing the Configuration

To verify that the Network Card-MS is operational:
1. Open a Web browser from a station connected to the same subnet as the card.
2. Enter the card's IP address in the address bar. The home page displays (see Figure 12).
Figure 12. Home Page
Continue to Chapter 3, "Configuring the Card" on page 13 for additional configuration options.
The IPv6 parameters are read only through the serioal line configuration menu. If IPv6 is
enabled, all IPv6 addresses of the card can be read from the HyperTerminal
section, "Configuring the Network With a DHCP Server" on page 10).
Eaton Network Card-MS User's Guide P-164000100—Rev 1 www.eaton.com/powerquality
Getting Started
(see the previous
®
12