Table of Contents
Advertisement
Using the Multi-Wavelength Meter
Displaying Wavelength and Power
Instrument states
Four different instrument states can be saved and recalled at a later time. The actual
instrument conditions that are saved are identical to those saved from the previous
state after power is turned on. These conditions are shown in
page
8-244. If drift measurements or an application (such as signal-to-noise) is on
when an instrument state is saved, it is off when that state is recalled.
To save an instrument state
1 Press the Setup key.
2 Press the SAV/RCL softkey.
3 Press the SAVE softkey.
4 Press one of the four SAVE softkeys to save the instrument state.
To recall a state
1 Press the Setup key.
2 Press the SAV/RCL softkey.
3 Press the RECALL softkey.
4 Press one of the four RCL softkeys to recall an instrument state.
Power bar
To control the power bar
1 Press the Setup key.
2 Press MORE twice, and then PWR BAR.
3 Press BAR ON to display the power bar, and press BAR OFF to hide the power bar
display.
48
Table 8-23 on
Advertisement
Table of Contents
