Keysight Technologies 86120B User Manual page 197

Syntax
Attribute Summary
Description
Syntax
Attribute Summary
SNR:REFerence:WNUMber
Sets the wave number used for the noise measurement reference in the signal-to-
noise calculation.
:CALCulate3:SNR:REFerence:WNUMber{?| {<real> | MINimum | MAXimum}}
<real> is a wave number value that is within the following limits:
Constant Description
MINimum 6060 cm
MAXimum 14286 cm
Preset State: unaffected by
*RST State: 6451.614 cm
SCPI Compliance: instrument specific
After entering this value, use the SNR:AUTO command to configure the instrument
to use this value in subsequent signal-to-noise calculations. The wave number
entered is converted internally to the corresponding frequency.
The default units for the <real> parameter are m
SNR[:STATe]
Turns the signal-to-noise calculation on and off.
:CALCulate3:SNR[:STATe]{?| {ON | OFF | 1 | 0}}
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
(1650 nm)
-1
(700 nm)
-1
-1
Programming Commands
CALCulate3 Subsystem
.
–1
195