Table of Contents
Advertisement
Syntax
Attribute Summary
Description
WLIMit:STOP:FREQuency
Sets the stopping frequency for the wavelength limit range.
:CALCulate2:WLIMit:STOP:FREQuency {?|{<real> | MINimum | MAXimum }}
<real> is a frequency value that is within the following limits:
Constant
Description
MINimum
start wavelength limit
MAXimum
428.2750 THz
Non-sequential command
Preset State: 249.8271 THz
*RST State: 249.8271 THz
SCPI Compliance: instrument specific
This command sets the stopping range for the wavelength limit. The default units for
the <real> parameter are Hz. The stop frequency value must be greater than or equal
to the start frequency value or the stop frequency will be clipped to the start fre-
quency and a "Data out of range" error will be generated.
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command
has the time to complete before sending any more commands to the instrument.
Refer to "Always force the Keysight 86120B to wait for non-sequential com-
mands" on page 92
for more information.
Programming Commands
CALCulate2 Subsystem
171
Advertisement
Table of Contents
