Table of Contents
Advertisement
Table 4-11. Programming Commands (4 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
:DISPlay:MARKer:MAXimum:NEXT
:DISPlay:MARKer:MAXimum:PREVious
:DISPlay:MARKer:MAXimum:RIGHt
:DISPlay[:WINDow]:GRAPhics:STATe
HCOPy Subsystem
:HCOPy:IMMediate
SENSe Subsystem
:SENSe:CORRection:DEVice
:SENSe:CORRection:ELEVation
:SENSe:CORRection:OFFSet:MAGNitude
:SENSe:CORRection:MEDium
:SENSe:DATA?
STATus Subsystem
:STATus:{OPERation | QUEStionable}:CON
Dition?
:STATus:{OPERation | QUEStionable}:EVE
Nt?
:STATus:{OPERation | QUEStionable}:ENA
Ble
:STATus:{OPERation | QUEStionable}:PTR
ansition
:STATus:{OPERation | QUEStionable}:NTR
ansition
:STATus:PRESet
SYSTem Subsystem
:SYSTem:ERRor?
Programming
Lists of Commands
Description
Moves the marker to the signal with the closest power
level just below the power level of the signal at the current
marker position.
Moves the marker to the signal with the closest power
level just above the power level of the signal at the current
marker position.
Moves marker to the next higher wavelength or
frequency.
Turns the instrument display of the power bars on and off.
Starts a printout.
Configures wavelength measurements for narrowband or
broadband devices.
Sets the elevation value used by the instrument to
compensate for air dispersion.
Sets the power offset value used by the instrument.
Sets the instrument to return the wavelength reading in a
vacuum when the parameter is on. Parameters are VAC
and AIR.
Queries the time domain samples of the input signal.
Returns the value for the condition register for the node.
Returns the value of the event register for the node.
Sets the enable register.
Sets the positive transition filter register.
Sets the negative transition filter register.
Presets the enable registers for all status nodes.
Queries an error from the error queue.
126
Code
I
I
I
S
S
I
I
S
I
I
S
S
S
S
S
S
S
Advertisement
Table of Contents
