Keysight Technologies 86120B User Manual page 172

Syntax
Attribute Summary
Description
Programming Commands
CALCulate2 Subsystem
WLIMit:STARt:WNUMber
Sets the starting wavenumber for the wavelength limit range.
:CALCulate2:WLIMit:STARt:WNUMber {?|{<real> | MINimum | MAXimum}}
<real> is a wavenumber value that is within the following limits:
Constant Description
MINimum 6060 cm
MAXimum wavelength limit stop value
Non-sequential command
Preset State: 6.060606E5 m
*RST State: 6.060606E5 m
SCPI Compliance: instrument specific
This command sets the starting range for the wavelength limit. The default units for
the <real> parameter value are m
equal to the stop wavenumber value or the start wavenumber will be clipped to the
stop wavenumber and a "Data out of range" error will be generated.
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command
has the time to complete before sending any more commands to the instrument.
Refer to "Always force the Keysight 86120B to wait for non-sequential com-
mands" on page 92 for more information.
170
-1
-1
-1
. The start wavenumber value must be less than or
-1