Access And Use The Display Menu System - Emerson Micro Motion 2700 Configuration And Use Manual

Table A-1:
Optical switch indicator
Solid red
Flashing red
A.3

Access and use the display menu system

The display menu system is used to perform various configuration, administrative, and
maintenance tasks.
Tip
The display menu system does not provide complete configuration, administrative, or maintenance
functions. For complete transmitter management, you must use another communications tool.
Prerequisites
To access the display menu system, operator access to either the Off-Line menu or the
Alarm menu must be enabled. To access the complete menu system, operator access
must be enabled for both the Off-Line menu and the Alarm menu.
Procedure
1.
2.
3.
Configuration and Use Manual
Optical switch indicator and optical switch states
At the transmitter display, activate the Scroll and Select optical switches
simultaneously until the display changes.
You will enter the Off-Line menu at any of several locations, depending on several
factors.
• If an alarm is active and access to the Alarm menu is enabled, you will see SEE
ALARM.
• If no alarm is active and Smart Meter Verification is enabled on the transmitter,
you will see ENTER METER VERFY.
• If no alarm is active and Smart Meter Verification is not enabled on the
transmitter, you will see OFF_LINE MAINT.
Use the Scroll and Select optical switches to navigate to your destination in the
display menu system.
• Use Scroll to move through a list of options.
• Use Select to choose the current option.
If CODE? appears on the display when you make a choice, enter the value that is
configured for Off-Line Password.
a. With the cursor flashing on the first digit, activate Scroll until the correct digit is
displayed, then activate Select.
b. Repeat this process for the second, third, and fourth digits.
State of optical switches
One optical switch is activated.
Both optical switches are activated.
Using the transmitter display
253