Set Up The Weights & Measures Application; Weights & Measures Application - Emerson Micro Motion 2700 Configuration And Use Manual

8 Set up the Weights & Measures
application
Topics covered in this chapter:
•
•
•
Information in this chapter is applicable only if your transmitter was ordered with the
Weights & Measures application.
8.1 Weights & Measures application
The Weights & Measures application is used to provide process data that is legal for
custody transfer applications when an approved method is used to read or obtain the
measurement.
Regulatory agencies
When installed, configured, and used as recommended by Micro Motion, the Weights &
Measures application is certified by the following regulatory agencies:
•
•
Depending on the regulatory agency that governs your installation, different setup,
configuration, and operation methods are applicable.
Secured vs. unsecured
When the Weights & Measures application is installed, the transmitter is always "secured"
or "unsecured." The transmitter leaves the factory in unsecured mode, with Status Alarm
A027: Security Breach active. Additionally, flow measurement may be disabled.
Measurement data from an unsecured transmitter cannot be used for custody transfer
applications.
To clear the alarm and enable flow measurement, you must configure the Weights &
Measures application and secure the transmitter. When the transmitter is secured, the
alarm is cleared and flow measurement is enabled automatically.
Security types and requirements
Before using the transmitter for Weights & Measures measurement, both metrological
security and physical security must be implemented.
Configuration and Use Manual
Weights & Measures application
Set up the Weights & Measures application using ProLink II
Set up the Weights & Measures application using ProLink III
NTEP (National Type Evaluation Program). NTEP requirements apply in the U.S.A.
and Canada.
OIML (Organization of Legal Metrology). OIML requirements apply in all other world
areas.
Set up the Weights & Measures application
139