Emerson Micro Motion 2700 Configuration And Use Manual page 252

Troubleshooting
3.
4.
244
a. Remove the core processor lid. The core processor is intrinsically safe and can be
opened in all environments.
b. Check the state of the core processor LED.
If you have an integral installation:
a. Loosen the four cap screws that fasten the transmitter to the base.
Figure 12-1: Integral installation components
Transition ring
4 x cap screws (4 mm)
b. Rotate the transmitter counter-clockwise so that the cap screws are in the
unlocked position.
c. Gently lift the transmitter straight up, disengaging it from the cap screws.
Important
Do not disconnect or damage the wires that connect the transmitter to the core
processor.
d. Check the state of the core processor LED.
If you have a 9-wire remote installation:
a. Remove the end-cap.
Base
®
Micro Motion Model 2700 Transmitters with Analog Outputs
Transmitter
Core processor