Festo CTEU-PB Electronics Description page 60

2. Commissioning
Create configuration
Modifying the address
2-24
Configuration of the modular part with STEP 7
Fill the configuration table with the device or devices connec-
ted to your bus node (see Fig. 2/7):
1. Click on the symbol of the valve terminal to be configured
in HW Config 1. The configuration table 2 will be dis-
played under the rack.
2. Open in the hardware catalogue 3 the module "CTEU-PB"
via the path PROFIBUS-DP > Additional Field Devices > Valves
> Festo AG und Co. KG > CTEU-PB.
3. Pull a bus node into slot 1 of the configuration table.
4. Pull the device connected to I-Port connection 1 into
slot 2 of the configuration table and assign the start add-
ress of the inputs or outputs in the "Properties - PROFIBUS
interface" dialogue window 4.
5. Repeat this step, if necessary, with the second I-Port
device connected to the bus node.
Note
Always pull the device connected to I-Port connection 1 as
a module without gaps into the configuration table first
and only after that do the same with the device connected
to I-Port connection 2.
1. Double-click on the corresponding line in the configura-
tion table 2.
2. Modify the starting address of the inputs/outputs in the
"Properties - DP Slave" dialogue window 4.
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English