Mounting - Festo CTEU-PB Electronics Description

1. Installation
1.2

Mounting

Mounting on valve terminal For mounting the bus node, a valve terminal from Festo with
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
The bus node can be directly mounted on appropriate equip-
ment (e.g. valve terminals with I-Port connection) from Festo
or decentralised on the electrical connection box.
Note
Information on mounting the bus node on the decentral-
ised electrical connection box type CAPC-... can be found
in the assembly instructions that accompany the connec-
tion box.
I-port connection is required.
Proceed as follows:
1. Inspect the seals and sealing surfaces on bus node and
valve terminal.
2. Plug the bus node onto the valve terminal in the right
position and without tilting.
3. First, lightly screw in the three self-tapping screws with a
Torx screwdriver (size T10). Use existing threads, if avail-
able.
4. Tighten the screws with 1.0 Nm.
1-5