Intended Use; Range Of Application And Certifications - Festo CTEU-PB Electronics Description

Contents and general safety instructions

Intended use

Range of application and certifications

Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
The bus node CTEU-PB documented in this description has
been designed exclusively for use as a station (slave) on the
PROFIBUS-DP fieldbus.
The bus node may only be used as follows:
– as intended
– in original condition, without unauthorised modifications.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
– in excellent technical condition.
The limit values specified for pressures, temperatures,
electrical data, torques etc. must be complied with.
Observe the regulations of the trade associations, German
Technical Control Board (TÜV), VDE stipulations or corres-
ponding national laws and regulations.
The product fulfils the requirements of EU directives and is
marked with the CE marking.
Standards and test values which the product complies with
and fulfils can be found in the Technical appendix. The
product-relevant EC directives can be found in the declaration
of conformity.
Certificates and declarations of conformity for this product
can be found at www.festo.com.
VII