Festo CTEU-PB Electronics Description page 90

3. Diagnostics
3-10
7 6 5 4 3
1
2nd step:
7
Evaluation of
the diagnostic
bytes
23
30
Fig. 3/3: Diagnostic steps
Note
The device-specific diagnostic information are only sent to
the master if transmission is activated.
In order to do this, set switch element 11 of the DIL
•
switch group to "ON" (see chap. 1.4.2).
In order to commission your fieldbus system, it may be
useful in some cases to switch off the device-specific dia-
gnostics.
2 1 0
Bit
1 1
Station status 1
1st step (evaluation of bit 0
and 2):
Bus node is voltage-free,
fieldbus plug is not plugged
in, ...
Projected configuration of the
bus node does not correspond
to the actual configuration.
device-specific diagnostics (see
Tab. 3/6)
Module-related diagnostics
(see Tab. 3/7)
Channel-related diagnostics (max.
11 messages)
(see Tab. 3/11)
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English