Festo CTEU-PB Electronics Description page 75

2. Commissioning
Status Designation
0
–
0
1
Check Param OK
2
Check Config OK
3
Reset communica-
tion
4
Hardware reset
Tab. 2/9: Status transitions – descriptions at Fig. 2/14
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
Description of the status transitions
Function
Initialisation was successful.
Checking of the parameters was successful.
Checking of the configuration was successful (comparison of the con-
figuration set at the DP master with the actually existing configuration
in the bus node).
After timeout or malfunction at the fieldbus or reset of communication,
fieldbus communication is restarted, e.g. after the fieldbus cable is un-
plugged and plugged back in or the DP master is restarted.
After the bus node is restarted, initialization of the bus node is started
anew.
2-39