Parameterisationwhen Being Switched On (Start Behaviour); Equipment Parameters - Festo CTEU-PB Electronics Description

2. Commissioning

2.6.1 Parameterisationwhen being switched on (start behaviour)

1
Master loads
parameter set in-
to the bus node
2
Bus node distrib-
utes parameter
set
3
I-Port devices 1
and 2 receive
parameter set
Fig. 2/11: Sequence of the start parameterisation

2.6.2 Equipment parameters

2-32
PLC/
DP
IPC
master
1
2
When the fieldbus system is switched on, the bus node is
parameterised as "Start parameterisation" through the para-
meter set stored in the DP master. The bus node then distrib-
utes the parameters in a module-oriented manner to the con-
nected equipment.
Proceed as follows:
1. Double click in the configuration table on the line of the
module which you wish to parameterise 1.
The corresponding dialogue window is displayed (see
Fig. 2/12).
2. Click on the parameter value which you wish to modify.
A list field with the possible values is opened 4.
3. Modify the value by clicking on and selecting it and con-
firm the entry with "OK".
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
3