Operation With The General Dp Master; Sending Parameterisation Data - Festo CTEU-PB Electronics Description

A. Technical appendix
A.3

Operation with the general DP master

A.3.1 Sending parameterisation data
Set_Prm
Octet 1: Station status
Bit Significance
0 —
1 —
2 —
3 WD_On
4 Freeze_Req
5 Sync_Req
6 Unlock_Req
7 Lock_Req
Tab. A/5: Octet 1: Station status
A-14
The parameterisation data is transferred from the DP master
to the bus node with the function Set_Prm.
Explanation
Reserved
Response monitoring of the bus node on/off:
0 = off
1 = on
0 = FREEZE mode not required by the master
1 = FREEZE mode set by the master
0 = SYNC mode not required by the master
1 = SYNC mode set by the master
Bit 7 Bit 6 Explanation
0 0 Min. T
SDR
0 1 Bus node is approved for other masters
1 0 Bus node is blocked for other masters
1 1 Bus node is approved for other masters
+ slave parameters may be overwritten
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English