Setting The Dil Switches; Removal And Mounting Of The Dil Switch Cover - Festo CTEU-PB Electronics Description

1. Installation
1.4

Setting the DIL switches

Parameters

1.4.1 Removal and mounting of the DIL switch cover

Dismounting
Mounting
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
With the DIL switches, you set the following parameters for
the bus node (incl./excl. connected equipment):
– Operating mode
– PROFIBUS station address
– Diagnostics mode
To set the bus node, the cover of the DIL switches must be
removed.
Caution
The bus node includes electrostatically sensitive devices.
Do not touch any electronic components.
•
Observe the handling specifications for electrostatically
•
sensitive devices.
They will help you avoid damage to the electronics.
Proceed as follows:
1. Switch off the power supply.
2. Unscrew the two mounting screws of the transparent cover.
3. Lift off the cover.
1. Place the cover carefully on the bus node.
Note
Make sure that the seal is seated correctly!
•
2. Tighten the two mounting screws at first hand-tight and
then with a max. torque of 0.4 Nm.
1-9