Festo CTEU-PB Electronics Description page 125

A. Technical appendix
Octet Designation
2 and 3 WD_Fact_1
WD_Fact_2
4 Minimum Station Delay Re-
sponder (min T
5 and 6 Ident_number
7 Group_Ident
8 DPV1 parameter status 1
9 DPV1 parameter status 2
10 DPV1 parameter status 3
11 Bus nodes
12 ... 23 I-Port connection 1
24 ... 35 I-Port connection 2
38 ... 198 User_Prm_Data
Tab. A/6: Octets 2 ... 198
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
Further octets
Explanation
Range 1...255: The response monitoring time of the
bus node is transferred with these two octets:
TWD [s] = 10ms x WD_Fact_1 x WD_Fact_2
The minimum time the bus node must wait, before
) the reply telegram may be sent to the DP master.
SDR
Transmits the manufacturer identifier (= 059E
the bus node; parameterisation telegrams to bus
nodes are only accepted if the transmitted and the
programmed Ident. Numbers match.
Not supported by bus nodes
Watchdog, fail safe mode and MS1 channel
DPV1 alarms on/off
DPV1 alarm types, other
Bit 1: tool change mode I-Port connection 1
Bit 2: tool change mode I-Port connection 2
Module code (3 bytes device ID and 1 byte type ID),
8 bytes device-specific parameters
Module code (3 bytes device ID and 1 byte type ID),
8 bytes device-specific parameters
Reserved
) of
h
A-15