Read Out Diagnostic Messages Via Controller - Festo CTEU-PB Electronics Description

4. Error handling

4.1.6 Read out diagnostic messages via controller

4-6
1. Check whether Freeze or Sync mode is set (see
chap. 2.1.4)
2. Check whether Fail State is activated on the bus node (DIL
switch position, see chap. 1.4).
The diagnostic messages of the bus node are dependent on
the controller used and its configuration and parameterisa-
tion. Further information can be found in chap.3.4 and
chap. 3.5 as well as in the documentation for your controller.
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English