Festo CTEU-PB Electronics Description page 57

2. Commissioning
Festo P.BE-CTEU-PB-OP+MAINT-EN en 1208NH English
Set up sub-network
13. Click on "New..." in the "Properties" dialogue windowto
set up a PROFIBUS sub-network (see Fig. 2/5).
14. Edit, if necessary, the "Transmission rate" und "Profile"
entries in the "Parameters" tab (see Fig. 2/5).
15. Click on "OK" in the two "Properties" dialogue windows in
succession to complete the setting of the PROFIBUS sub-
network.
Install GSD and symbol files
Install the GSD and symbol files in the next steps: These must
be reachable via your PC. Source and notes for the selection,
see chap. 2.3.1.
1. Start the installation function via the HW Config menu:
[Options] - [Install GSD File ...].
2. Update the hardware catalogue through the menu com-
mands [Options] - [Update Catalog].
The slaves installed through the GSD file are read into the
hardware catalogue.
3. Open in the hardware catalogue the path PROFIBUS-DP >
Additional Field Devices > Valves > Festo AG und Co. KG >
CTEU-PB.
All modules that can be connected to the CTEU-PB bus
node now appear.
Install bus node as slave
1. Mark the line view of the PROFIBUS sub-network in the
main window (2, see Fig. 2/6).
2. Open in the hardware catalogue the path PROFIBUS-DP >
Additional Field Devices > Valves > Festo AG und Co. KG >
CTEU-PB.
2-21