How To Install - Danfoss ADAP-KOOL AKD 102 Operating Instructions Manual

Mechanical Installation

4.2 How to Install

4.2.1 Mechanical Mounting
All IP20 enclosure sizes as well as IP21/ IP55 enclosure sizes except A2 and A3 allow side-by-side installation.
If the IP 21 Enclosure kit (130B1122 or 130B1123) is used on enclosure A2 or A3, there must be a clearance between the
drives of min. 50 mm.
For optimal cooling conditions allow a free air passage above and below the frequency converter. See table below.
1. Drill holes in accordance with the measurements given.
2. You must provide screws suitable for the surface on which you want to mount the frequency converter. Re-tighten
all four screws.
Table 4.2 Mounting frame sizes A5, B1, B2, C1 and C2 on a non-solid back wall, the drive must be provided with a back plate A
due to insufficient cooling air over the heat sink.
®
ADAP-KOOL Drive Operating Instructions
Air passage for different enclosures
Enclosure: A2 A3
a (mm): 100 100
b (mm): 100 100
®
MG.11.L4.02 - ADAP-KOOL Drive
A4 A5 B1 B2
100 100 200 200
100 100 200 200
4 4
C1 C2
200 225
200 225
23