9.5.1 Error codes E200
extended diagnostic information)
The specified FDL address is out of the range.
No FDL address has been specified.
The specified FDL address belongs to the local station
The specified FDL address belongs to a reserved or
temporarily reserved station.
No extended diagnostic information is found in the
specified FDL address.
9.5 Error Codes
9.5.1 Error codes E200H to E2FFH (Error codes generated when reading extended diagnostic information)
Table9.4 Error codes E200
(Error codes generated when reading
Check if the specified FDL address is correct, and retry.
Change the QJ71PB92V operation mode to mode 3, and
When a value is set for Switch 2 of the intelligent function
module switches, delete it and leave it as blank (no
Error codes E200