Mitsubishi Electric Melsec Q Series User Manual page 187

6
PARAMETER SETTING
(b) When "Slave Specific Transfer" is used
Figure 6.13 Number of Automatic Refresh Parameter Settings (When Set by "Slave Specific Transfer")
When the automatic refresh of I/O data is set by "Slave Specific Transfer" (i.e.
when changing the refresh target device on a per-DP-Slave basis), the following
number of automatic refresh parameters can be set per QJ71PB92V.
Max. number of settings = {(Number of connected DP-Slaves)
6.6 Automatic Refresh Parameters
6.6.4 Number of set automatic refresh parameters
Set auto-refresh parameters
for (No. of DP Slaves
connected to QJ71PB92V 2).
Up to 3 auto-refresh
parameters can be set.
1
2} + 3
2
3
4
Set the total number
of the auto-refresh
5
parameters.
6
7
8
6
- 22