Mitsubishi Electric Melsec Q Series User Manual page 304

9
TROUBLESHOOTING
Error Code
E564 Application error was detected on the DP-Slave side.
H
Request-not-supported error was detected on the DP-Slave
E565
H
side.
E566 Incorrect index was detected on the DP-Slave side
H
E567 Incorrect data length was detected on the DP-Slave side.
H
E568 Incorrect slot number was detected on the DP-Slave side.
H
E569 Incorrect data type was detected on the DP-Slave side.
H
Access to an access-disabled area was attempted from the
E56A
H
DP-Slave side.
E56B Access is not available on the DP-Slave side.
H
E56C The access was rejected on the DP-Slave side.
H
E56D Incorrect access range was detected on the DP-Slave side.
H
E56E Incorrect request was detected on the DP-Slave side.
H
E56F Incorrect data type was detected on the DP-Slave side.
H
Incorrect parameter in the request was detected on the DP-
E570
H
Slave side.
Resource error was detected during read processing on the
E571
H
DP-Slave side.
Resource error was detected during write processing on the
E572
H
DP-Slave side.
E573 The resource is already in use on the DP-Slave side.
H
E574 There is no resource that can be used on the DP-Slave side.
H
E575 Incorrect parameter exists in the ACK request.
H
E576
H
There is no alarm for which ACK can be requested.
E580
H
E581 The alarm specified for ACK request is not found.
H
E582 Use of the alarm function is not allowed.
H
E590
H
E591
H
E592
H
E593
H
E594
H
E595 Hardware failure
H
E596
H
E597
H
E598
H
E599
H
E59A
H
E59B Acyclic communication is executed to the same DP-Slave.
H
E59C There is no executable resource.
H
E59D There is an invalid parameter setting.
H
9
- 22 9.5 Error Codes
9.5.4 Error codes E500H to E5FFH (Error codes generated when reading alarms)
Table9.7 Error codes E500H to E5FFH (Continued)
Error Description
Error codes E564
Action
Check if the request data supported by the DP-Slave is
correctly set or not, and retry.
For details, refer to the manual for the DP-Slave.
Check the alarm status on the specified DP-Slave and
retry.
Check if the DP-Slave supports the alarm function or not,
and retry.
Please consult your local Mitsubishi representative.
Verify that the Acyclic communication is completed, and
retry.
Check the parameter settings and then retry.
to E59D
H H
(To the next page)