Mitsubishi Electric Melsec Q Series User Manual page 189

6
PARAMETER SETTING
Table6.11 Intelligent Function Module Switch Setting Items (For the redundant system support function)
Item
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
Table6.12 Intelligent Function Module Switch Setting Items (For the QJ71PB92D-compatible function)
Item
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
1) For the redundant system support function
Set the standby master FDL address when the QJ71PB92V is mounted in a redundant system.
If the standby master FDL address setting is failed, an error code is stored in the Local station error
information area (Un\G23071). (
Disabled: No setting (blank)
Enabled: Refer to the following (Set only when using the redundant system support function)
1
No setting (blank).
If any setting exists, delete it.
2) For the QJ71PB92D-compatible function
Set whether to continue or stop the I/O data communication with the DP-Slave when the CPU stop
error occurs.
Continue : No setting (blank)
Stop : 0001
H
9244
H
No setting (blank).
If any setting exists, delete it.
6.7 Parameter Setting by GX Works2
Description
Section 9.5.6)
0
Standby master FDL address
Setting range: 0
Description
H
to 7D (0 to 125)
H H
6
- 24
1
2
3
4
5
6
7
8