Mitsubishi Electric Melsec Q Series User Manual page 167

6
PARAMETER SETTING
Is the QJ71PB92V mounted to
a redundant system?
Yes
Set the standby master FDL address in GX Works2.
Write the parameters set on GX Works2 to a redundant CPU.
(2) Precautions for using the QJ71PB92V in a redundant system and writing
Item
Both systems A and B
Backup mode
Separate mode
1)
*1
End
Figure 6.1 Parameter Setting Procedure (Continued)
parameters through GX Configurator-DP
(a) Parameter writing from GX Configurator-DP
When writing parameters from GX Configurator-DP, the write target varies
depending on the operation mode of the redundant CPU.
Table6.1 Parameter Writing from GX Configurator-DP
Target for parameter writing
One system
6.1 Parameter Setting Procedure
No
Section 6.7
£
GX Works2 Version 1 Operating Manual (Common)
£
When clicking the
to both systems A and B.
When parameters are written, the operation mode of the
redundant CPU is changed to Separate mode and
tracking transfer is stopped.
*1
When clicking the
to both systems A and B.
When clicking the
to the one system.
The tracking transfer of the redundant CPU is stopped
when parameters are written.
Description
OK
button, parameters are written
Yes button, parameters are written
No button, parameters are written
(To the next page)
6
1
2
3
4
5
6
7
8
- 2