Mitsubishi Electric Melsec Q Series User Manual page 180

Profibus-dp master module
Hide thumbs Also See for Melsec Q Series:
Table of Contents

Advertisement

6
PARAMETER SETTING
1)
Is the auto refresh to be
set for an intelligent function module
other than the QJ71PB92V using
GX Developer or GX Works2?
YES
• When using GX Developer
Specify a GX Developer project in the
"Project Properties" window.
• When using GX Works2
Operate both GX Configurator-DP and
GX Works2 with reference to the method
described in the GX Configurator-DP
Version7 Operating Manual.
In the "CPU Device Access" window, select
"AutoRefresh".
When using the data consistency function,
enable the Consistency setting in the Master
parameter settings.
Write the auto-refresh parameters to the
*1
QCPU.
Completed
6
- 15
6.6 Automatic Refresh Parameters
6.6.1 Automatic refresh parameter setup procedure
NO
Figure 6.8 Automatic refresh parameter setting procedure (Continued)
* 1 When using the QJ71PB92V in a redundant system, write the same parameters to the redundant
CPUs in systems A and B.
GX Configurator-DP Version7
Operating Manual
Section 6.6.2
Section 6.3
Section 6.6.3

Advertisement

Table of Contents
loading

Table of Contents