Cleaning And Disinfection; System Components - AGFA CR 30-X User Manual

Cleaning and Disinfection

All appropriate policies and procedures should be followed to avoid
contamination of the staff, patients and device. All existing universal
precautions should be taken to avoid that the digitizer and its accessories
come into contact with potential contaminations. Details about cleaning can
be found in the following pages.
To clean the exterior of the digitizer:
1. Switch off the digitizer.
2. Remove the power plug from the socket.
Switch off the UPS, if installed.
3. Wipe the exterior of the digitizer with a clean, soft, damp cloth.
Use a mild soap or detergent if required but never use ammonia-based
cleaner.
4. Plug the power plug into the socket.
Switch on the UPS, if installed.

System components

For cleaning and disinfection instructions of the plates and cassettes, refer to
the CR 30-X/CR 30-Xm Plates and Cassettes User Manual.
For cleaning and disinfection instructions of the ID Tablet, refer to the
document Getting Started with the ID Tablet.
CR 30-X, CR 30-Xm | Introduction to CR 30-X/CR 30-Xm | 33
CAUTION:
Damage or deterioration of safety provisions can cause
injury of the operator.
Remove the power plug from the socket before cleaning the
exterior of the device.
CAUTION:
Make sure no liquid gets in the digitizer.
Note: Do not open the digitizer for cleaning. No components
inside the digitizer require cleaning by the user.
2386I EN 20151020 1518