AGFA CR 30-X User Manual page 82

82 | CR 30-X, CR 30-Xm | Operating CR 30-X/CR 30-Xm
Condition
Error during
read-out of
the ID data
Error during
writing on RF-
tag after
scanning
process
Erasure lamp
failed during
scanning cycle
Image plate
detected in
the digitizer
during self-
test
2386I EN 20151020 1518
Control PC message
Errors concerning Identification
"Error during read-
out of cassette chip
data. Remove
cassette."
"Error during writing
on cassette chip after
successful scan. Erase
the image plate
again."
Digitizer errors
"Failure at erasure
module. Please
restart digitizer. If
error remains, please
contact service.
Image plate must be
erased after repair
again."
"Image plate during
self-test in the
digitizer detected.
The image plate was
moved back into the
cassette. Please check
whether the image is
Status
indicator
plate from the
transport unit
manually and close
the digitizer. Switch
on the digitizer. After
restart remove the
cassette and put the
image plate back into
the cassette.
Red,
flashing.
Confirm the message
with the OK button
After
and re-identify the
unlocking:
cassette.
green,
constant
Confirm the message
Red,
with the OK button on
flashing.
PC, remove the
cassette, push the
After
erase button on the
unlocking:
digitizer and re-enter
green,
the cassette for a
constant
manual erase cycle.
Red, Restart the digitizer or
constant call service.
After power failure a
Red,
remaining image
flashing.
plate, in the digitizer,
After
will be detected and
unlocking:
the forementioned
green,
error message will be
constant
displayed.
Action