General Safety Instructions - AGFA CR 30-X User Manual

42 | CR 30-X, CR 30-Xm | Introduction to CR 30-X/CR 30-Xm

General safety instructions

• Make sure that the digitizer is constantly monitored in order to avoid
inappropriate handling, especially by children.
• Only trained service personnel must make repairs. Only authorized service
personnel must make changes to the digitizer.
• If there is any visible damage to the machine casing, do not start nor use
the digitizer.
• Do not override or disconnect the integrated safety features.
• Do not apply excessive shock or vibration to the digitizer during operation
(e.g. putting cassettes on top of the device). This may decrease the image
quality. Neither should the device be moved during operation.
• Switch off the device before performing any maintenance work or repairs.
Disconnect the digitizer from the mains before making repairs or
performing any maintenance activities during which live electrical
components may be exposed.
• As is the case for all technical devices, the digitizer must be operated,
cared for and serviced correctly. A regular quality control is
recommended.
2386I EN 20151020 1518
CAUTION:
Strictly observe all warnings, cautions, notes and safety
markings within this document and on the product.
CAUTION:
All Agfa medical products must be used by trained and qualified
personnel.
CAUTION:
The user must be aware that any error (crash / lock up) leading
to an image processing failure can cause loss of diagnostic
information.
CAUTION:
The digitizer is not suitable for scanning imaging plates (IPs)
exposed with a dose higher than 5000 µG.
CAUTION:
Bad image quality can cause a need to retake the image or
cause delayed diagnosis.
Do not operate the device in direct sunlight, max. 2500 lux.
CAUTION:
While every care has been taken, it is possible that minor errors
still exist in the product. It is unlikely that a minor error could
result in incorrect (unexpected) device operation.