Switching Off - AGFA CR 30-X User Manual

68 | CR 30-X, CR 30-Xm | Getting started

Switching Off

It is recommended to switch off the digitizer at the end of the day.
To stop the system:
1. Switch off the digitizer by pressing the main switch.
1.
2. Switch off the ID Tablet.
Only in a configuration with ID Tablet.
For more information, refer to the document Getting Started with the ID
Tablet.
3. Stop NX.
NX can be stopped in two ways:, either by logging out of Windows or by
using the Exit NX action button.
For detailed information about stopping NX, refer to the NX User Manual,
document 4420.
4. Turn off the UPS (optional accessory) to disconnect the control PC and the
digitizer.
Press and hold the Off button until the long beep ceases (approximately
five seconds).
2386I EN 20151020 1518
Note: Only switch off the digitizer if you do not intend to digitize
emergency image plates overnight. Switching on the digitizer takes
approximately 60 seconds. During this time emergency digitizing is
not possible!
Note: After switch off, the device is still in stand-by mode. To
remove the device from the mains supply disconnect the mains
plug.
Main switch
1