Troubleshooting Checklist - AGFA CR 30-X User Manual

80 | CR 30-X, CR 30-Xm | Operating CR 30-X/CR 30-Xm

Troubleshooting Checklist

The troubleshooting for a malfunction of the digitizer consists of two parts:
• The first is always to check the status indicator on the digitizer.
• Other errors need more detailed information and instructions to repair the
malfunction, or they can only be fixed by a Service engineer. In this case,
consult the Digitizer Remote Display messages on the control PC.
Related Links
Status Indicator
Topics:
• General Errors
• Connection Problems
• Errors During Operation
General Errors
The digitizer does
not start up.
Connection Problems
In case the status indicator of the digitizer is blinking red, the user should look
at the "status" of the Digitizer Remote Display to decide whether digitizer
internal problems or connection problems occurred.
If an error message is displayed on the NX PC, the user is informed which
actions to perform to solve the problem.
In case no error message is displayed on the screen, a connection problem
occurred.
2386I EN 20151020 1518
on page 50
Error
Check the power supply. If the power supply is ok, call
your local Service engineer.
CAUTION:
Operation failure of the device can cause delayed diagnosis.
Check if Digitizer Remote Display is running.
Action