74 | CR 30-X, CR 30-Xm | Operating CR 30-X/CR 30-Xm
Reading the Initialization Data of an Image Plate
The initialization data stored in the RF-tag of the tray can be read via the NX
workstation.
Reading the initialization data of an image plate can be necessary in the
following cases:
• to find a specific cassette,
• to check if the IP sensitivity code (printed on the rear side of the IP) is
corresponding with the initialized data on the chip,
• to check if the correct IP was inserted after cleaning (in case of doubt),
• to check the cycle counter of the cassette,
Topics:
•
Reading the Initialization Data in a Configuration with Fast ID
•
Reading the Initialization Data in a Configuration with ID Tablet
2386I EN 20151020 1518