Safety Instructions For Laser Products - AGFA CR 30-X User Manual

32 | CR 30-X, CR 30-Xm | Introduction to CR 30-X/CR 30-Xm

Safety Instructions for Laser Products

The digitizer is a Class 1 Laser Product. It uses one laser diode of a 80 mW
type, classification class IIIb, wavelength 640-670 nm. The laser beam's
deflection frequency is 120 1/s up to 170 1/s. The laser beam divergence is
12 mrad.
Under normal operating conditions - device with all covers - there can be no
laser radiation outside the digitizer.
The technical concept does not allow the user to remove the top cover. The
concept provides maximum reliability that no image plate jam can occur in
the post scan area.
However, the user is allowed to open the front cover, e.g. to solve cassette or
image plate jams at the front side. When opening the front panel, all motor
driven system movements will be stopped (including the laser).
2386I EN 20151020 1518
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
LASERKLASSE 1
CAUTION:
User interventions other than those described in this
manual can be hazardous with regard to laser radiation.
CAUTION!
CLASS 3B LASER RADIATION:
WHEN OPEN AVOID DIRECT EVITAR LA EXPOSICIÓN AL HAZ
EXPOSURE TO THE BEAM! CUANDO LA TAPA EST Á ABIERTA.
VORSICHT !
LASERSTRAHLUNG KLASSE 3B: FAISCEAU LASER CLASSE 3B:
WENN ABDECKUNG GEÖFFNET QUAND CAPOT OUVERT ÉVITER
NICHT DEM STRAHL AUSSETZEN! DE S´EXPOSER AU RAYÓN!
CUIDADO!
RAYO LASER CLASE 3B:
ATTENTION!