General - AGFA CR 30-X User Manual

General

Always take into account the markings and labels provided on the inside and
outside of the machine. A brief overview of these markings and labels and
their meaning is given below.
CR 30-X, CR 30-Xm | Introduction to CR 30-X/CR 30-Xm | 29
Safety warning, indicating that the manuals should be
consulted before making any connections to other
equipment. The use of accessory equipment not
complying with the equivalent safety requirements of
this digitizer may lead to a reduced level of safety of the
resulting system. Consideration relating to the choice of
accessory equipment shall include:
• Use of the accessory equipment in the patient
vicinity,
• Evidence that the safety certification of the
accessory equipment has been performed in
accordance with respective IEC standards (e.g. IEC
60950 for data processing equipment or IEC
60601-1 for medical equipment).
In addition all configurations must comply with the
requirements for medical electrical systems according
to IEC 60601-1. The party that makes the connections
acts as system configurator and is responsible for
complying with the systems standard.
If required contact your local service organization.
In order to reduce the risk of electric shock, do not
remove any covers.
Caution hot:
Keep hands clear from the erasure unit.
Supplementary protective earth connector:
Provides a connection between the digitizer and the
potential equalization busbar of the electrical system as
found in medical environments. This plug should never
be unplugged before the power is turned off and the
power plug has been removed.
It is recommended to use the supplementary protective
earth connection as additional safety measure.
2386I EN 20151020 1518