Optional System Components - AGFA CR 30-X User Manual

14 | CR 30-X, CR 30-Xm | Introduction to CR 30-X/CR 30-Xm

Optional System Components

Topics:
• Powerware 5115 UPS
• Full Leg Full Spine Application Components
Powerware 5115 UPS
The system can be extended with the Powerware 5115 uninterruptible power
system (UPS). The UPS is available in two voltage types: 110 V and 230 V.
The Powerware 5115 uninterruptible power system (UPS) protects the PC
when the main power supply has crashed, and avoids the loss of images. UPS
configuration requires special software. This software will be installed and
configured by an Agfa service technician.
With the Powerware 5115, you can safely eliminate the effects of power
disturbances and guard the integrity of your system.
To install the Powerware 5115 UPS into the system, proceed as follows:
1. Plug the UPS power cord into the input connector at the UPS rear panel.
2. Plug the other side of the UPS power cord into a power outlet.
3. Plug the digitizer and the NX workstation into the appropriate UPS output
receptacles.
In case of power failure, the batteries of the UPS supplies power to the
digitizer and the NX workstation.
Full Leg Full Spine Application Components
• CR FLFS Cassette and Plate set (e.g. CR MD4.0T FLFS).
• NX FLFS license (including Stitching software).
• CR Full Body Cassette Holder.
• Anti-scatter grid (optional).
• CR EasyLift (optional).
For more information and instructions on the FLFS application, refer to the
document 4408, CR Full Leg Full Spine User Manual.
2386I EN 20151020 1518